back to press releases 
Glen Ellyn, IL - BLACKHAWK ENVIRONMENTAL COMPANY custom designs
the Anchor Pump® for difficult-to-pump wells providing
pumping solutions for environmental, landfill, groundwater
and industrial applications. Blackhawk specializes in manufacturing
quality pumps for demanding pumping applications.
Featuring a top head drive oil well sucker rod pump, a custom
designed Anchor Pump effectively recovers hard-to-pump liquids
with a smooth controlled flow recovery and has the ability
to tune the recovery speed and strength to the yield of the
formation being pumped. These Anchor Pumps are available in
pneumatic or electric and manufactured in a range of sizes
and designs depending on the degree of application difficulty.
The Anchor Pump is reciprocating action plunger pump that
mechanically recovers fluid from the well bottom, independent
of the well's liquid level, while maintaining a constant flow
recovery rate. Unlike other pumps, where discharge performances
are limited to the inlet air pressure, the Anchor Pump reaches
to the lowest possible level, regardless of dirt, silt, heat
or slime, and can be installed in wells as small as 2"
in diameter.
The Anchor Pump's deep recovery capabilities can produce
400 psi of pressure. Anchor Pump can be set for a flow range
of 0 to 11 US GPM. Anchor Pumps feature uncomplicated controls
which make installation and on-site maintenance easy - even
under the toughest conditions.
For more information,
please contact BLACKHAWK ENVIRONMENTAL COMPANY
21W161 Hill Avenue, Glen Ellyn, IL 60137. Phone: 630-469-4916.
Fax: 630-469-4896.
Or email us.
For more
information about this pump and other Blackhawk Environmental
quality pumping and control products, call today
630-469-4916. |
back to press releases |
